|
Firmware for the LC Meter Mk3
The BASCOM source code and .hex file for the Arduino Nano in the LC Meter Mk3.
You can upload this file to the Arduino Nano using a free program like AVRDUDESS which is available at the following link:
https://blog.zakkemble.net/avrdudess-a-gui-for-avrdude/
Select the "Arduino" programmer and set the baud rate to 57600. Make sure the correct COM port is selected.
|
|
0.96in cyan OLED with SSD1306 controller
A 4-pin (I²C) OLED screen in cyan. The display active area is approximately 22 x 11mm while the whole module is about 27 x 19mm.
|
|
LC Meter Mk3 PCB [CSE220503C]
The main PCB for the new LC Meter.
Double-sided PCB with plated through holes, solder mask and silkscreen overlay.
91.5 x 63.5mm.
|
|
LC Meter Mk3 add-on PCB [CSE200603]
A small PCB that can be used to connect leaded or SMD components to the LC Meter Mk3 for testing.
20.5 x 33mm.
|
|
LC Meter Mk3 PCB patterns (PDF download) [CSE220503C & CSE220603]
One PDF with the PCB patterns for the LC Meter Mk2.
Both sides of both designs are in a single PDF.
|
|
Lid panel label & drilling template for the LC Meter Mk3
The lid panel artwork and drilling details for the LC Meter Mk3, in separate PDFs.
Note that there are two versions of the artwork on two separate pages, depending on whether you fit the option switch.
|
|
Short-form kit for the LC Meter Mk3
A kit that includes the PCB for the LC Meter Mk3 and all the parts that mount on it, plus the battery holder. You just need to add the case, front panel label and AA cells. The Arduino Nano is not programmed.
Check the parts list link below for the full details. The photo shows the kit after assembly.
|