|
Firmware for the Advanced SMD Test Tweezers [0410622A.HEX]
The PIC24FJ256GA702 microcontroller firmware (HEX files) plus C language source code and MPLAB X project for the Advanced SMD Test Tweezers.
|
|
0.96in cyan OLED with SSD1306 controller
A 4-pin (I²C) OLED screen in cyan. The display active area is approximately 22 x 11mm while the whole module is about 27 x 19mm.
|
|
Advanced SMD Test Tweezers PCB set [04106221+04106212 {blue}]
A set of PCBs to build the Advanced Test Tweezers. Includes the main board (04106221) plus two Tweezer arms (04106212) and the sticker to cover the rear of the PCB.
Double-sided PCBs with plated through holes, blue solder mask and silkscreen overlay.
One of 28 x 36mm and two of 100 x 8mm.
|
|
PIC24FJ256GA702-I/SS programmed for the Advanced SMD Test Tweezers (0410622A.HEX)
PIC24FJ256GA702-I/SS 16-bit SMD microcontroller programmed with the firmware for the Advanced Test Tweezers (0410622A.HEX).
|
|
Advanced SMD Test Tweezers PCB patterns (PDF download) [04106221+04106212]
A PDF with the PCB patterns for the Advanced Test Tweezers.
Both sides of both PCBs are in a single PDF.
This would be difficult to etch; it is mainly provided as a reference.
|
|
Advanced SMD Test Tweezers sticker artwork (PDF download)
A PDF file with the sticker/PCB rear protection artwork for the Advanced Test Tweezers.
The PDF includes an alternative version that's better optimised for printing rather than being made as a sticker.
|
|
Advanced SMD Test Tweezers kit
A set of all the parts needed to build the SMD Test Tweezers. All you need to add is a CR2032 lithium coin cell.
For a complete list of all parts in the kit, see the link immediately below. The programming header is not included because the supplied chip is pre-programmed.
Note: the photo shows the fully assembled Tweezers.
|