 |
Firmware (ASM and HEX) files for the Mains Power-Up Sequencer
The HEX and ASM files for the 8-bit PIC16F1459 in the Mains Power-Up Sequencer project.
There are two versions of the firmware. The original has an A suffix. The different version described in the July 2024 issue, for use with inverters and generators, has an M suffix. Make sure you use the right one for your build.
|
 |
Mains Power-Up Sequencer PCB [10108231]
The PCB for the Mains Power-Up Sequencer project.
Double-sided PCB with plated through holes, green solder mask and silkscreen overlay.
203 x 134mm.
|
 |
PIC16F1459-I/P programmed for the Repurposed Mains Power-Up Sequencer (1010823M.HEX)
A PIC16F1459-I/P 8-bit DIP microcontroller programmed with the repurposed firmware for the Mains Power-Up Sequencer (1010823M.HEX). This is the new version of the firmware from the July 2024 issue, not the original one.
Note that this microcontroller is also available as part of the hard-to-get parts set for that project.
|
 |
Mains Power-Up Sequencer PCB pattern (PDF download) [10108231]
A PDF file with the PCB pattern for the Mains Power-Up Sequencer.
It is a double-sided design and both layers are in a single file.
|
 |
Panel labels and cutting diagrams for the Mains Power-Up Sequencer
This three-page PDF has both versions of the lid panel labels, plus the case drilling/cutting diagrams for the Mains Power-Up Sequencer.
|
 |
Mains Power-Up Sequencer hard-to-get parts
This set of parts includes the critical components needed to build the Mains Power-Up Sequencer: the PCB, the programmed microcontroller, all other semiconductors and the insulating LED bezels.
There are quite a few other parts required, but they are all standard types that should be available from your usual electronics retailer.
Click the link immediately below for a full list of all parts included in this set.
Note: photo shows fully assembled PCB, including parts not included in this set.
|
