The module shown here is designed to do just about everything that the original LM3909 did –
and more!
There are a couple of differences – the most obvious one is
that the module is quite a bit larger than the DIP-sized LM3909.
Supply voltage is much more usable 3V-18V, compared to the
LM3909’s 1.15V to 6V. Current consumption may be as low as 100µA, rather than
the LM3909’s typical 0.55mA. Pulse width may be controlled more easily than it
could with the LM3909.
And not least, this circuit can pulse two LEDs alternately. It
will also serve, among other things, as a quartz clock driver and continuity
tester. Rather than present a host of similar circuits, however, a single module
is shown here, along with a table showing how the module can be used in a
variety of ways.
Circuit description
IC1a is a Schmitt RC oscillator or "clock generator". Only the
capacitor, C1, can be regarded as a fixed part of the oscillator; R1,
R2, RX, RY and D2 are all components
which can be changed to allow the module to perform in different ways.
